R3204P16-HP Load Balancing Module System Management Configuration Guide-6PW101

15
Figure 10 Configuration page
Configuring password authentication for console login
Configuration prerequisites
You have logged in to the device.
By default, you can log in to the device through the console port without authentication and have user
privilege level 3 after login. For information about logging in to the device with the default configuration,
see “Configuration requirements.”
Configuration procedure
Follow these steps to configure password authentication for console login:
To do… Use the command…
Remarks
Enter system view system-view —
Enter console user interface
view
user-interface console number —
Configure the authentication
mode as local password
authentication
authentication-mode password
Required
By default, you can log in to the device
through the console port without
authentication and have user privilege
level 3 after login.
Set the local password
set authentication password
{ cipher | simple } password
Required
By default, no local password is set.