R3204P16-HP Load Balancing Module System Management Configuration Guide-6PW101

23
Figure 14 Configuration page
Configuring password authentication for Telnet login
Configuration prerequisites
You have logged in to the device.
By default, you can log in to the device through the console port without authentication and have user
privilege level 3 after login. For information about logging in to the device with the default configuration,
see “Configuration requirements.”
Configuration procedure
Follow these steps to configure password authentication for Telnet login:
To do… Use the command…
Remarks
Enter system view system-view —
Enable Telnet telnet server enable
Required
By default, the Telnet service is disabled.
Enter one or multiple VTY
user interface views
user-interface vty first-number
[ last-number ]
—
Specify the password
authentication mode
authentication-mode password
Required
By default, authentication mode for VTY user
interfaces is scheme.
Set the local password
set authentication password
{ cipher | simple } password
Required
By default, local password is admin .