R3204P16-HP Load Balancing Module System Management Configuration Guide-6PW101

24
To do… Use the command… Remarks
Configure the user privilege
level for login users
user privilege level level
Required
0 by default.
Configure common settings
for VTY user interfaces
—
Optional
See “Configuring common settings for VTY
user interfaces (optional).”
When you log in to the device through Telnet again, perform the following steps:
• You are required to enter the login password. A prompt such as <HP> appears after you enter the
correct password and press Enter, as shown in Figure 15.
• If “
All user interfaces are used, please try later!” is displayed, it means the number of current
concurrent login users exceed the maximum. Please try later.
Figure 15 Configuration page
Configuring scheme authentication for Telnet login
Configuration prerequisites
You have logged in to the device.
By default, you can log in to the device through the console port without authentication and have user
privilege level 3 after login. For information about logging in to the device with the default configuration,
see “Configuration requirements.”
Configuration procedure
Follow these steps to configure scheme authentication for Telnet login