R3204P16-HP Load Balancing Module System Management Configuration Guide-6PW101

When you log in to the device through Telnet again:

• You are required to enter the login username and password. A prompt such as <HP> appears after

you enter the correct username (for example, admin) and password and press Enter, as shown

in Figure 16.

• A

fter you enter the correct username and password, if the device prompts you to enter another

password of the specified type, you will be authenticated for the second time. In other words, to

pass authentication, you must enter a correct password as prompted.

• If “All user interfaces are used, please try later!” is displayed, it means the current login users

exceed the maximum number. Please try later.

Figure 16 Configuration page

Configuring common settings for VTY user interfaces (optional)

Follow these steps to configure Common settings for VTY user interfaces:

To do… Use the command…

Remarks

Enter system view system-view —

Enter management Ethernet interface

view

interface interface-type

interface-number

—

Specify an IP address for the

management Ethernet interface

ip address ip-address

{ mask | mask-length }

Required

By default, the IP address of the

management Ethernet interface is

192.168.0.1/24.

Return to system view quit —

Enable display of copyright

information

Optional

Enabled by default.