R3204P16-HP Load Balancing Module System Management Configuration Guide-6PW101

32
After the above-mentioned configuration, you can log in to the web-based configuration interface of the
LB module by using username userA and password 123 456 .
Configuring the web login function
If the web function is disabled, log in to the device via the console port, and perform the following
configuration:
• Enable HTTP or HTTPS service
• Configure the IP address of the management Ethernet interface
• Configure a username and password
The device supports the following web login methods:
• HTTP login—The Hypertext Transfer Protocol (HTTP) is used for transferring web page information
across the Internet. It is an application-layer protocol in the TCP/IP protocol suite. The
connection-oriented Transport Control Protocol (TCP) is adopted at the transport layer. Currently, the
device supports HTTP 1.0.
• HTTPS login—The Secure HTTP (HTTPS) refers to the HTTP protocol that supports the Security Socket
Layer (SSL) protocol. HTTPS uses SSL to encrypt the data exchanged between the HTTPS client and
the server to ensure data security and integrity. You can define a certificate attribute-based access
control policy to allow legal clients to access the device securely and prohibit illegal clients.
The following table shows the configuration requirements of web login.
Ob
j
ect Re
q
uirements
Device
Configure the IP address of the management Ethernet interface
Make sure the device and the PC can reach each other
Configuring HTTP login
Required to use one approach
Configuring HTTPS login
PC
Install a web browser
Obtain the IP address of the management Ethernet interface of the device
Configuring HTTP login
Follow these steps to configure HTTP login:
To do… Use the command…
Remarks
Enter system view system-view —
Enable the HTTP service ip http enable
Required
Enabled by default.
Configure the HTTP service
port number
ip http port port-number
Optional
80 by default.
If you execute the command multiple times,
the last one takes effect.