R3204P16-HP Load Balancing Module System Management Configuration Guide-6PW101

35
To do… Use the command… Remarks
Specify the Telnet
service type for the local
user
service-type web
Required
By default, no service type is configured for the local user.
Exit to system view quit —
Enter management
Ethernet interface view
interface interface-type
interfac-number
Required
Assign an IP address
and subnet mask to the
management Ethernet
interface
ip address ip-address
{ mask | mask-length }
Required
By default, the IP address of the management Ethernet
interface is 192.168.0.1/24.
Displaying and maintaining web login
To do… Use the command… Remarks
Display information about web users
display web users
Available in any view
Display HTTP state information display ip http Available in any view
Display HTTPS state information display ip https Available in any view
Web login example
HTTP login example
Network requirements
As shown in Figure 20, the PC is connected to the device over an IP network. The IP address of the device
i s 10 .15 3 .17. 82 / 24 .
Figure 20 Network diagram for configuring HTTP login
Configuration procedure
1. Configuration on the device
# Log in to the device via the console port and configure the IP address of the management Ethernet
interface GigabitEthernet 0/1 of the device.
<LB> system-view
[LB] interface GigabitEthernet0/1
[LB-GigabitEthernet0/1] ip address 10.153.17.82 255.255.255.0
[LB-GigabitEthernet0/1] quit
# Create a local user named admin, and set the password to admin for the user. Specify the Telnet
service type for the local user, and set the command level to 3 for this user.