R3204P16-HP Load Balancing Module System Management Configuration Guide-6PW101

36
[LB] local-user admin
[LB-luser-admin] service-type web
[LB-luser-admin] authorization-attribute level 3
[LB-luser-admin] password simple admin
2. Configuration on the PC
# On the PC, run the web browser. Enter the IP address of the device in the address bar, 192.168.0.58
in this example. The web login page appears, as shown in Figure 21.
Figure 21 Web login page
# Type the user name, password, verify code, select English, and click Login. The homepage appears.
After login, you can configure device settings through the web interface.
HTTPS login example
Network requirements
As shown in Figure 22, to prevent unauthorized users from accessing the Device, configure HTTPS login
as follows:
• Configure the LB module as the HTTPS server, and request a certificate for it.
• The Host acts as the HTTPS client. Request a certificate for it.
In this example, Windows Server acts as the CA. Install Simple Certificate Enrollment Protocol (SCEP)
add-on on the CA. The name of the CA that issues certificates to the Device and Host is new-ca.
Before performing the following configuration, make sure that the LB module, Host, and CA can reach
each other.