R3204P16-HP Load Balancing Module System Management Configuration Guide-6PW101

43
Configuring NMS login
Connect the Ethernet port of the PC to the management Ethernet interface of the LB module, as shown
in Figure 26. Mak
e sure the PC and the management Ethernet interface can reach each other.
Figure 26 Network diagram for configuring NMS login
Follow these steps to configure SNMPv3 settings:
To do… Use the command…
Remarks
Enter system view system-view —
Enable SNMP agent
snmp-agent
Optional
Disabled by default.
You can enable SNMP agent with
this command or any command
that begins with snmp-agent.
Configure an SNMP
group and specify its
access right
snmp-agent group v3 group-name
[ authentication | privacy ] [ read-view
read-view ] [ write-view write-view ]
[ notify-view notify-view ] [ acl acl-number ]
Required
By default, no SNMP group is
configured.
Add a user to the
SNMP group
snmp-agent usm-user v3 user-name
group-name [ [ cipher ] authentication-mode
{ md5 | sha } auth-password [ privacy-mode
{ 3des | aes128 | des56 } priv-password ] ]
[ acl acl-number ]
Required
If the cipher keyword is specified,
both auth-password and
priv-password are cipher text
passwords.
Follow these steps to configure SNMPv1 and SNMPv2c settings:
To do… Use the command…
Remarks
Enter system view system-view —
Enable SNMP agent snmp-agent
Optional
Disabled by default.
You can enable SNMP agent
with this command or any
command that begins with
snmp-agent.
Create or update MIB view information
snmp-agent mib-view
{ excluded | included }
view-name oid-tree [ mask
mask-value ]
Optional
By default, the MIB view
name is ViewDefault and
OID is 1.