R3204P16-HP Load Balancing Module System Management Configuration Guide-6PW101

46
Logging in to the LB module from the network
device
Logging in to the LB module from the network device
Configuring the AUX user interface of the LB module
Before logging in to the LB module from the network device, you need to configure the AUX user interface
of the LB module.
Follow these steps to configure the AUX user interface:
To do… Use the command…
Remarks
Enter system view system-view —
Enter AUX user interface view user-interface aux number —
Specify the none authentication
mode
authentication-mode none
Required
By default, the AUX user interface
uses password authentication.
Configure the user privilege level user privilege level level
Required
0 by default. HP recommends you
to set it to 3.
Logging in to the LB module
Use the following command to log in to the LB module. After login, the terminal screen displays the CLI
of the LB module. To return to the CLI on the device, press Ctrl+K.
Follow the step below to log in from the network device to the LB module:
To do… Use the command…
Remarks
Log in from the network device to
the LB module
When the network device works
in standalone mode:
oap connect slot slot-number
Required
Available in user view of the network
device
When the network device works
in IRF mode:
oap connect chassis
chassis-number slot slot-number