R3204P16-HP Load Balancing Module System Management Configuration Guide-6PW101

65
Table 8 Device basic information configuration items
Item Descri
p
tion
Sysname Set the system name
Configuring the device name in the CLI
A device name identifies a device in a network. In the system, the device name is the same as the prompt
of the CLI. For example, if the device name is Sysname, the prompt of user view is <Sysname>.
Follow these steps to configure the device name:
To do… Use the command…
Remarks
Enter system view system-view —
Configure the device name sysname sysname
Optional
By default, the device name is H3C .
Setting the idle timeout timer
NOTE:
You can set the idle timeout timer in the web interface or the CLI.
Setting the idle timeout timer in the web interface
You can set the idle timeout timer for a logged-in user. The system logs an idle user off the web interface
after the timer expires.
Select System > Device Management from the navigation tree, and select the Web Management tab to
enter the page shown in Figure 39
Figure 39 Web management