R3204P16-HP Load Balancing Module System Management Configuration Guide-6PW101

Table 9 Web management configuration items

Item Descri

tion

Idle timeout Set the idle timeout period for a logged-in user

Setting the idle timeout timer in the CLI

You can set the idle timeout timer for a logged-in user. After a user logs in to the SecBlade LB module, if

the user does not perform any operation before the timer expires, the SecBlade LB module automatically

tears down the connection to the user. If you set this timer to 0, the connection is not automatically torn

down.

Follow these steps to set the idle timeout timer:

To do… Use the command…

Remarks

Enter system view system-view —

Enter user interface view

user-interface { first-num1

[ last-num1 ] | { aux | console |

vty } first-num2 [ last-num2 ] }

—

Set the idle timeout timer idle-timeout minutes [ seconds ]

Required

10 minutes by default

Enabling the display of copyright information

• With the display of copyright information enabled, the copyright information is displayed when a

user logs in through Telnet or SSH, or when a user quits user view after logging in to the SecBlade

LB module through the console port, AUX port, or asynchronous serial interface. The copyright

information is not displayed under other circumstances. The format of copyright information is

shown as follows:

**************************************************************************

* Without the owner's prior written consent, *

* no decompiling or reverse-engineering shall be allowed. *

**************************************************************************

• With the display of copyright information disabled, the copyright information is never displayed.

Follow these steps to enable the display of copyright information:

To do… Use the command…

Remarks

Enter system view system-view —

Enable the display of copyright

information

Optional

Enabled by default.