R3204P16-HP Load Balancing Module System Management Configuration Guide-6PW101

70
Configuring a command to be executed at a specified time
Follow these steps to configure a command to be executed at a specified time:
To do… Use the
command… Remarks
Enter system view system-view —
Create a scheduled task and enter job view job job-name Required
Specify the view in which the task will be
executed
view view
Required
You can specify only
one view for a
schedule task.
Configure the
scheduled task
Configure a command to be
executed repeatedly in a
specified duration
time time-id { one-off |
repeating } at time [ month-date
month-day | week-day
week-daylist ] command
command
Required
Use either of the
commands.
Configure a command to be
executed at a specified time
time time-id at time date
command command
NOTE:
A
fter you confi
g
ure a command to be executed at a specified time, chan
g
in
g
the system time will affect the
execution time of the command.
Configuring a command to be executed after a specified delay time
Follow these steps to configure a command to be executed after a specified delay time:
To do… Use the
command… Remarks
Enter system view system-view —
Create a scheduled task
and enter job view
job job-name Required
Specify the view in which
the task will be executed
view view
Required
You can specify only one view for a
schedule task.
Configure a command to
be executed after a
specified delay time
time time-id { one-off | repeating } delay
time command command
Required
NOTE:
This configuration is not related to the system time. That is, the command will be executed after the dela
y
time even if the system time changes.
Scheduled task configuration example
Network requirements
Configure scheduled tasks on the SecBlade to enable interfaces GigabitEthernet 0/1, GigabitEthernet
0/2, and GigabitEthernet 0/3 at 8:00 and disabled them at 18:00 on working days every week, to
control the access of the PCs connected to these interfaces.