R3204P16-HP Load Balancing Module System Management Configuration Guide-6PW101

77
Figure 42 Add a local user
The detailed information for configuring a local user is shown in Table 11.
Table 11 Local user configuration items
Item Descri
p
tion
User Name
Enter a username. A username is case sensitive, and cannot contain any of these
characters: “/”, “\”, “:”, “|”, “*”, “?”, “<”, “>”, “@” and “"”.
TIP:
A username may contain spaces. However, leading spaces and trailing spaces are
always ignored. An all-space input is considered null.
User Privilege Level Set the user privilege level of the user.
Service Type
Set the service type that the user can use, including FTP, SSH, Telnet and Terminal.
TIP:
For a user to log in to the LB module through the web interface, you must select the
service type Telnet for the user.
Password Set the password
Confirm Password Reset the password, which must be the same with the previously set password.
Local user configuration example
Network requirements
As shown in Figure 43, configure the LB module so that user Emily can log in from GigabitEthernet 0/1
through the web interface and view the data on the module but cannot perform any configurations.
Figure 43 Local user configuration network diagram