R3204P16-HP Load Balancing Module System Management Configuration Guide-6PW101

88
To do… Use the command… Remarks
Enable ACSEI server acsei server enable
Required
Disabled by default.
Follow these steps to configure the LB module:
To do… Use the command…
Remarks
Enter system view system-view —
Configure the unified
management VLAN
unified-management
vlan vlan-id
Required
By default, no unified management VLAN is configured.
The unified management VLAN is used to forward
management packets among multiple systems.
Enter the view of
interface on the LB
module connecting to
the A7500
interface interface-type
interface-number
Required
Enable ACSEI client acsei-client enable
Required
Disabled by default.
NOTE:
• Configure the unified management VLAN before enabling the ACSEI function; otherwise, the unified
multi-system management function cannot operate normally.
• The systems to be managed uniformly must be configured with the same management VLAN.
• Create a local user on the device to enable the user to lo
g
in to the device to perform Web confi
g
uration.
To enable the user to manage the Web configuration pages of multiple systems, you need to confi
g
ure
the same local user on the systems, and the level of the local user must be at least 1.
• For more information about ACSEI, see the chapter “Logging in to the LB module from the network
device.”
• For how to configure a local user, see
Security Configuration Guide .
Unified multi-system management configuration
example
Network requirements
As shown in Figure 50, an LB module is inserted in the A7500. It is required that user Host be able to
configure the LB module through the web interface after logging in to the LB module, without the need to
log in to the A7500 and LB module respectively.