R3204P16-HP Load Balancing Module Typical Configuration Examples-6PW101

Figure 27 Save the current configuration

Network adapter configurations on a server

In DR-mode load balancing, you need to assign a loopback address on each server. The loopback

address must be the same as the virtual service IP address configured on the LB module. If the server runs

the Windows system, you need to add a loopback network adapter. The gateway address of the

physical network adapter on the server is the IP address of the VLAN-interface 200 on the A7503 switch.

1. Loopback network adapter installation procedure

• Connect the loopback network adapter to the server host. Go to Start > Settings > Control Panel,

and then double-click the Add Hardware icon.

Figure 28 Control panel

• Click Next.