R3204P16-HP Load Balancing Module Typical Configuration Examples-6PW101

<Sysname> system-view

[Sysname] interface GigabitEthernet0/1 //Enter management interface view

[Sysname-GigabitEthernet0/1] ip address 192.168.254.200 255.255.255.0 //Configure the IP

address of the management interface as 192.168.254.200

[Sysname-GigabitEthernet0/1] quit

<Sysname> save //Save the configuration

2. Enter http://192.168.254.200 in the IE address bar to enter the login page of the LB_1 module

web interface. Type the default username admin and password admin, type the verify code, select

the language, and then click Login.

Figure 42 LB_1 module login page

CLI configuration

1. Configuration procedures

# Create 10GE Layer 3 subinterfaces and configure IP addresses for them.

[Sysname] interface Ten-GigabitEthernet 0/0.1

[Sysname-Ten-GigabitEthernet0/0.1] vlan-type dot1q vid 30

[Sysname-Ten-GigabitEthernet0/0.1] ip address 5.0.0.2 255.0.0.0

[Sysname-Ten-GigabitEthernet0/0.1] quit

[Sysname] interface Ten-GigabitEthernet 0/0.23

[Sysname-Ten-GigabitEthernet0/0.23] vlan-type dot1q vid 23

[Sysname-Ten-GigabitEthernet0/0.23] ip address 6.0.0.2 255.0.0.0

[Sysname-Ten-GigabitEthernet0/0.23] quit

[Sysname] interface Ten-GigabitEthernet 0/0.24

[Sysname-Ten-GigabitEthernet0/0.24] vlan-type dot1q vid 24

[Sysname-Ten-GigabitEthernet0/0.24] ip address 7.0.0.2 255.0.0.0

[Sysname-Ten-GigabitEthernet0/0.24] quit

# Add a static route.

ip route-static 0.0.0.0 0.0.0.0 5.0.0.1

2. Configuration file

interface GigabitEthernet0/1

port link-mode route

ip address 192.168.254.200 255.255.255.0

interface GigabitEthernet0/2

port link-mode route

interface GigabitEthernet0/3