R3721-F3210-F3171-HP High-End Firewalls Access Control Command Reference-6PW101

24
# Create IPv6 advanced ACL rules to permit inbound and outbound FTP packets.
<Sysname> system-view
[Sysname] acl ipv6 number 3002
[Sysname-acl6-adv-3002] rule permit tcp source-port eq ftp
[Sysname-acl6-adv-3002] rule permit tcp source-port eq ftp-data
[Sysname-acl6-adv-3002] rule permit tcp destination-port eq ftp
[Sysname-acl6-adv-3002] rule permit tcp destination-port eq ftp-data
# Create IPv6 advanced ACL rules to permit inbound and outbound SNMP and SNMP trap packets.
<Sysname> system-view
[Sysname] acl ipv6 number 3003
[Sysname-acl6-adv-3003] rule permit udp source-port eq snmp
[Sysname-acl6-adv-3003] rule permit udp source-port eq snmptrap
[Sysname-acl6-adv-3003] rule permit udp destination-port eq snmp
[Sysname-acl6-adv-3003] rule permit udp destination-port eq snmptrap
rule (IPv6 basic ACL view)
Syntax
rule [ rule-id ] { deny | permit } [ counting | fragment | logging | source { ipv6-address prefix-length |
ipv6-address/prefix-length | any } | time-range time-range-name | vpn-instance vpn-instance-name ] *
undo rule rule-id [ counting | fragment | logging | source | time-range | vpn-instance ] *
View
IPv6 basic ACL view
Default level
2: System level
Parameters
rule-id: Specifies a rule ID, which ranges from 0 to 65534. If no rule ID is provided when you create an
ACL rule, the system automatically assigns it a rule ID. This rule ID takes the nearest higher multiple of the
numbering step to the current highest rule ID, starting from 0. For example, if the rule numbering step is
5 and the current highest rule ID is 28, the rule is numbered 30.
deny: Denies matching packets.
permit: Allows matching packets to pass.
counting: Counts the number of times the IPv6 ACL rule has been matched.
fragment: Applies the rule only to non-first fragments. A rule without this keyword applies to both
fragments and non-fragments.
logging: Logs matching packets. This function requires that the module that uses the ACL supports
logging.
source { ipv6-address prefix-length | ipv6-address/prefix-length | any }: Matches a source IP address.
The ipv6-address and prefix-length arguments represent a source IPv6 address and address prefix length
in the range 1 to 128. The any keyword represents any IPv6 source address.
time-range time-range-name: Specifies a time range for the rule. The time-range-name argument takes a
case-insensitive string of 1 to 32 characters. It must start with an English letter. If the time range is not
configured, the system creates the rule; however, the rule using the time range can take effect only after
you configure the timer range.