R3721-F3210-F3171-HP High-End Firewalls Access Control Configuration Guide-6PW101

132
# Configure dm1 as the default ISP domain for all users. Then, if a user enters a username without any
ISP domain at logon, the authentication and accounting methods of the default domain will be used for
the user.
[Firewall] domain default enable dm1
3. Configure portal authentication
# Configure a portal server on the Firewall, making sure that the IP address, port number and URL match
those of the actual portal server.
[Firewall] portal server newpt ip 192.168.0.111 key portal port 50100 url
http://192.168.0.111:8080/portal
# Enable portal authentication on the interface connecting the host.
[Firewall] interface GigabitEthernet 0/2
[Firewall–GigabitEthernet0/2] portal server newpt method direct
[Firewall–GigabitEthernet0/2] quit
Verifying the configuration
After the above configuration, execute the following command to see whether the portal configuration
has taken effect:
[Firewall] display portal interface GigabitEthernet 0/2
Interface portal configuration:
GigabitEthernet0/2: Portal running
Portal server: newpt
Authentication type: Direct
Authentication domain:
Authentication network:
address : 0.0.0.0 mask : 0.0.0.0
The user can initiate portal authentication by using the HP iNode client or by accessing a Web page. All
the initiated Web requests will be redirected to the portal authentication page
h t t p : / / 19 2 .16 8 . 0 .111:8080/portal. Before passing portal authentication, the user can access only the
authentication page. After passing portal authentication, the user can access Internet resources.
After the user passes the portal authentication, you can use the following command to view the portal
user information on the Firewall.
[Firewall] display portal user interface GigabitEthernet 0/2
Index:19
State:ONLINE
SubState:NONE
ACL:NONE
Work-mode:stand-alone
MAC IP Vlan Interface
---------------------------------------------------------------------
0015-e9a6-7cfe 2.2.2.2 0 GigabitEthernet 0/2
On interface GigabitEthernet0/2:total 1 user(s) matched, 1 listed.
Configuring re-DHCP portal authentication
Network requirements
As shown in Figure 118 :