R3721-F3210-F3171-HP High-End Firewalls Access Control Configuration Guide-6PW101

144
4. Configure the portal server detection function on the access device, so that the access device can
detect the status of the portal server by cooperating with the portal server heartbeat function.
5. Configure the portal user information synchronization function, so that the access device can
synchronize portal user information with the portal server by cooperating with the portal user
heartbeat function.
NOTE:
• Configure IP addresses for the host, Firewall, and servers as shown in Figure 123 an
d make sure that
they can reach each other.
• Configure the RADIUS server properly to provide authentication/accounting functions for users.
Configuring the portal server.
NOTE:
This example assumes that the portal server runs on IMC PLAT 5.0-E0101L02 and IMC UAM 5.0-E0101.
# Configure the portal server.
Log in to IMC and select the Service tab. Then, select Portal Service Management > Server from the
navigation tree to enter the portal server configuration page, as shown in Figure 124.
• C
onfigure the portal server heartbeat interval and user heartbeat interval.
• Use the default value for other parameters.
Figure 124 Portal server configuration
# Configure an IP address group.
Select Portal Service Management > IP Group from the navigation tree to enter the portal IP address
group configuration page. Click Add to enter the pageshown in Figure 125.