R3721-F3210-F3171-HP High-End Firewalls Access Control Configuration Guide-6PW101

145
• Enter the IP group name.
• Enter the start IP address and end IP address of the IP address group. Make sure that the IP address
of the user host is within this IP address group.
• Select a service group. By default, the group Ungrouped is used.
• Select the IP group type Normal.
Figure 125 Adding an IP address group
# Add a portal device.
Select Portal Service Management > Device from the navigation tree to enter the portal device
configuration page. Click Add to enter the page shown in Figure 126.
• En
ter the device name NAS.
• Enter the IP address of the Firewall's interface connected to the host.
• Enter the key, which must be the same as that configured on the Firewall.
• Set whether to enable IP address reallocation. Direct portal authentication is used in this example,
and therefore select No from the Reallocate IP list.
• Set whether to support the portal server heartbeat and user heartbeat functions. In this example,
select Yes for both Support Server Heartbeat and Support User Heartbeat.