R3721-F3210-F3171-HP High-End Firewalls Access Control Configuration Guide-6PW101

216
Configuring the RADIUS server on IMC PLAT 5.0
This section uses IMC PLAT 5.0 (E0101H03) and IMC UAM 5.0 SP1 (E0101P03) .
1. Add an access device:
a. Log in to IMC, click the Service tab, and then select User Access Manager > Access Device
Management > Access Device from the navigation tree.
b. Click Add to configure an access device as follows:
Set the shared key for authentication and accounting to expert.
Set the ports for authentication and accounting to 1812 and 1813, respectively.
Select Device Management Service as the service type.
Select HP(General) as the access device type.
Select the access device from the device list or manually add the device with the IP address of
10.1.1.2.
c. Click OK.
The IP address of the access device specified here must be the same as the source IP address of the
RADIUS packets sent from SecPath, which is chosen in this order:
{ IP address specified with the nas-ip command on the access device
{ IP address specified with the radius nas-ip command on the access device
{ IP address of the outbound interface (the default)
Figure 156 Adding an access device
2. Add a user for device management:
a. Click the User tab, and then select Access User View > Device Mgmt User from the navigation
tree.
b. Click Add to configure a device management account as follows:
Enter the account name hello@bbb and set the password.
Select Telnet as the service type.
Set the EXEC privilege level to 3. This value identifies the privilege level of the Telnet user after
login and defaults to 0.