R3721-F3210-F3171-HP High-End Firewalls Access Control Configuration Guide-6PW101

229
b. Click Add to configure an access user account as follows:
Select the user hello from the IMC Platform or add the user if it does not exist.
Enter the account name portal and set the password.
Select the service Portal auth/acct for the access user account.
Configure other parameters as needed.
c. Click OK.
Figure 169 Adding an access user account
Configuring the portal server on IMC PLAT 5.0
This section uses IMC PLAT 5.0 (E0101H03) and IMC UAM 5.0 SP1 (E0101P03) .
1. Configure the portal server:
a. Log in to IMC, click the Service tab, and then select User Access Manager > Portal Service
Management > Server from the navigation tree.
b. Enter the URL address of the portal authentication login page in the format of
http://ip:port/portal, where ip and port are the same as those configured during IMC UAM
installation. Usually, the default port 8080 is used.
c. Leave the default settings for other parameters and click OK.