R3721-F3210-F3171-HP High-End Firewalls Getting Started Command Reference-6PW101

70
nms monitor-interface
Syntax
nms { primary | secondary } monitor-interface interface-type interface-number
undo nms { primary | secondary } monitor-interface
View
System view
Default level
3: Manage level
Parameters
primary: Specifies the primary NMS-connected interface.
secondary: Specifies the secondary NMS-connected interface.
interface-type interface-number: Type and number of the interface to be monitored.
Description
Use nms primary monitor-interface to specify the primary NMS-connected interface..
Use nms secondary monitor-interface to specify the secondary NMS-connected interface.
Use undo nms monitor-interface to remove the configurations.
By default, no NMS-connected interface is specified on the firewall.
• You can configure one primary and one secondary interface for the device to communicate with the
NMS, but the firewall monitors only one of them at one time. If the IP address of the monitored
interface in UP state changes, whether because of manual reassignment or DHCP reassignment, the
device notifies the NMS of the new IP address.
• If you configure both the primary and secondary monitored interfaces, the firewall monitors the
primary one first.
The following matrix shows the command and firewall compatibility:
Command F1000-A-EI/ S-EI F1000-E F5000 Firewall module
nms monitor-interface Yes No No No
Examples
# Configure GigabitEthernet 0/1 as the primary NMS-connected interface.
<Sysname> system-view
[Sysname] nms primary monitor-interface GigabitEthernet 0/1
reboot
Syntax
reboot
View
User view