R3721-F3210-F3171-HP High-End Firewalls Getting Started Command Reference-6PW101

76
recovered after T1-T time. If T>=T1, the down port is recovered immediately. For example, if the
detection timer is set to 30 seconds and you change it to 10 seconds (T1=10) two seconds after the
port is shut down (T=2), this port will be recovered 8 seconds later. If the detection timer is set to 30
seconds and you change it to 2 seconds ten seconds after the port is shut down, this port is
recovered immediately.
• If the detection timer is set to 0, the protocol module never automatically recovers the port. You need
to manually bring up the port by using the undo shutdown command or change the detection timer
to a non-zero value.
Examples
# Set the port status detection timer to 100 seconds.
<Sysname> system-view
[Sysname] shutdown-interval 100
sysname
Syntax
sysname sysname
undo sysname
View
System view
Default level
2: System level
Parameters
sysname: Name of the firewall, which is a string of 1 to 30 characters.
Description
Use sysname to set the device name.
Use undo sysname to restore the default.
The default name is HP.
A device name identifies a device in a network and works as the user view prompt at the CLI. For
example, if the device name is Sysname, the user view prompt is <Sysname>.
Examples
# Set the name of the firewall to R2000.
<Sysname> system-view
[Sysname] sysname R2000
[R2000]
system-failure
Syntax
system-failure { maintain | reboot }
undo system-failure { maintain | reboot }