R3721-F3210-F3171-HP High-End Firewalls Getting Started Guide-6PW101

Feature and hardware compatibility

Feature F1000-A-EI/S-EI

F1000-E

F5000 Firewall module

FIPS No No No Yes

in method Default state

Logging in to the CLI:

Logging in through the console port

By default, login through the console port is enabled, no username or

password is required, and the user privilege level is 3.

Logging in through telnet

By default, you can log in to a device through Telnet with the IP

address 192.168.0.1/24 (the IP address of the management

interface GigabitEthernet 0/0), login username admin, password

admin, and user privilege level 3.

Logging in through SSH

By default, SSH is disabled. To use SSH service, complete the

following configuration tasks:

• Enable the SSH function and configure SSH attributes.

• Assign an IP address to the device's management interface and

configure routes to make sure the interface and the SSH client can

reach each other.

• Enable scheme authentication for VTY login users.

• Configure the user privilege level of VTY login users (0 by default).

Logging in to the Web interface

By default, you can log in to a device through web with the IP address

192.168.0.1/24 (IP address of the management interface

GigabitEthernet 0/0), login username admin, and password admin.

Configuring NMS login

By default, you cannot log in to a device through a network

management station (NMS). To do so, log in to the device through the

console port, and complete the following configuration:

• Assign an IP address to the device’s management interface, and

configure routes to make sure the interface and the NMS can reach

each other.

• Configure SNMP basic parameters.

Logging in to the firewall module from

the network device

After configuring the network device and the firewall module

properly, you can log in to the firewall module from the network

device.