R3721-F3210-F3171-HP High-End Firewalls Getting Started Guide-6PW101

47
CAUTION:
Before configuring the IP address of the management Ethernet interface of the firewall module on the
network device, you must configure the same IP address on the firewall module. Otherwise, the NMS
cannot access the firewall module by using the IP address.
Configuring NMS login
Connect the Ethernet port of the PC to the management interface of the device, as shown in Figure 31.
Make sure the PC and the management interface can reach each other.
Figure 31 Network diagram
To configure SNMPv3 settings:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enable SNMP agent.
snmp-agent
Optional.
Disabled by default.
You can enable SNMP agent with this
command or any command that
begins with snmp-agent.
3. Configure an SNMP
group and specify its
access right.
snmp-agent group v3 group-name
[ authentication | privacy ]
[ read-view read-view ] [ write-view
write-view ] [ notify-view
notify-view ] [ acl acl-number ]
By default, no SNMP group is
configured.
4. Add a user to the SNMP
group.
snmp-agent usm-user v3 user-name
group-name [ [ cipher ]
authentication-mode { md5 | sha }
auth-password [ privacy-mode
{ 3des | aes128 | des56 }
priv-password ] ] [ acl acl-number ]
If the cipher keyword is specified, both
auth-password and priv-password are
cipher text passwords.
To configure SNMPv1 and SNMPv2c settings:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enable SNMP agent.
snmp-agent
Optional.
Disabled by default.
You can enable SNMP agent
with this command or any
command that begins with
snmp-agent.