R3721-F3210-F3171-HP High-End Firewalls Getting Started Guide-6PW101

To set the idle timeout timer:

1. Select Device Management > Device Basic > Web Management from the navigation tree to enter

the page shown in Figure 49.

2. Set the idle timeout timer value.

3. Click Apply.

Figure 49 Web management

Setting the idle timeout timer at the CLI

You can set the idle timeout timer for a logged-in user. After a user logs in to the firewall, if the user does

not perform any operation when the timer expires, the firewall automatically tears down the connection

to the user. If you set this timer to 0, the firewall does not tear down the connection automatically.

To set the idle timeout timer:

Ste

Command

Remarks

1. Enter system view.

system-view N/A

2. Enter user interface view.

user-interface { first-num1

[ last-num1 ] | { console | vty }

first-num2 [ last-num2 ] }

N/A

3. Set the idle timeout timer.

idle-timeout minutes [ seconds ] 10 minutes by default

Enabling display of copyright statement

The firewall by default displays the copyright statement when a Telnet or SSH user logs in, or when a

console user quits user view. You can disable or enable the function as needed. The following is a sample

**************************************************************************

* Without the owner's prior written consent, *

* no decompiling or reverse-engineering shall be allowed. *

**************************************************************************

To enable the display of copyright information:

Ste

Command

Remarks

1. Enter system view. system-view N/A