R3721-F3210-F3171-HP High-End Firewalls Getting Started Guide-6PW101

Ste

Command

Remarks

4. Add commands to the job.

• Configure a command to run at a

specific time and date:

time time-id at time date

command command

• Configure a command to run at a

specific time:

time time-id { one-off |

repeating } at time [ month-date

month-day | week-day

week-daylist ] command

command

• Configure a command to run

after a delay:

time time-id { one-off |

repeating } delay time command

command

Use any of the commands.

Changing a clock setting does not

affect the schedule set by using the

time at or time delay command.

Scheduled job configuration example

Network requirements

Configure scheduled tasks on Firewall to enable interfaces GigabitEthernet 0/1, GigabitEthernet 0/2,

and GigabitEthernet 0/3 at 8:00 and disabled them at 18:00 on working days every week, to control

the access of the PCs connected to these interfaces.

Figure 52 Network diagram

Configuration procedure

# Enter system view.

<Firewall> system-view

# Create scheduled job pc1, and enter its view.

[Firewall] job pc1

# Configure the job to be executed in the view of GigabitEthernet 0/1.

[Firewall-job-pc1] view gigabitethernet 0/1

# Configure the firewall to start GigabitEthernet 0/1 at 8:00 on working days every week.