R3721-F3210-F3171-HP High-End Firewalls Getting Started Guide-6PW101

90
e. Select the service type Web.
f. Enter the password aabbcc.
g. Enter the confirm password aabbcc.
h. Set the virtual device to which the user belongs to Root.
i. Click Apply.
Configuring a local user at the CLI
For more information, see Access Control Configuration Guide.
Controlling user logins
User login control configuration is only available at the CLI.
The device provides the following login control methods:
Lo
g
in Throu
g
h Lo
g
in control methods ACL used
Telnet
Configuring source IP-based Telnet login control Basic ACL
Configuring source and destination IP-based Telnet
login control
Advanced ACL
Configuring source MAC-based Telnet login control Ethernet frame header ACL
NMS Configuring source IP-based SNMP login control Basic ACL
Web Configuring source IP-based Web login control Basic ACL
Configuring Telnet login control
Before configuration, determine the permitted or denied source IP addresses, source MAC addresses,
and destination IP addresses.
Configuring source IP-based Telnet login control
Basic ACLs match the source IP addresses of packets, so you can use basic ACLs to implement source
IP-based login control over Telnet users. Basic ACLs are numbered from 2000 to 2999. For more
information about ACL, see Access Control Configuration Guide.
To configure source IP-based Telnet login control:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Create a basic ACL and enter
its view, or enter the view of
an existing basic ACL.
acl [ ipv6 ] number acl-number
[ name acl-name ] [ match-order
{ config | auto } ]
By default, no basic ACL exists.
3. Configure rules for this ACL.
rule [ rule-id ] { permit | deny }
[ source { sour-addr sour-wildcard
| any } | time-range time-name |
fragment | logging ]*
N/A
4. Exit the basic ACL view.
quit N/A