R3721-F3210-F3171-HP High-End Firewalls High Availability Command Reference-6PW101

96
Speed or Duplex: (a)/A - auto; H - half; F - full
Type: A - access; T - trunk; H - hybrid
Interface Link Speed Duplex Type PVID Description
BAGG1 DOWN auto A A 1
Last 300 seconds input rate: 0 bytes/sec, 0 bits/sec, 0 packets/sec
Last 300 seconds output rate: 0 bytes/sec, 0 bits/sec, 0 packets/sec
0 packets input, 0 bytes, 0 drops
0 packets output, 0 bytes, 0 drops
# Display brief information about Layer 3 aggregate interface Route-Aggregation 1.
<Sysname> display interface route-aggregation 1 brief
The brief information of interface(s) under route mode:
Link: ADM - administratively down; Stby - standby
Protocol: (s) - spoofing
Interface Link Protocol Main IP Description
RAGG1 DOWN DOWN --
# Display information about all Layer 2 aggregate interfaces in DOWN state.
<Sysname> display interface bridge-aggregation brief down
The brief information of interface(s) under bridge mode:
Link: ADM - administratively down; Stby - standby
Interface Link Cause
BAGG1 DOWN Not connected
# Display information about all Layer 3 aggregate interfaces in DOWN state.
<Sysname> display interface route-aggregation brief down
The brief information of interface(s) under route mode:
Link: ADM - administratively down; Stby - standby
Interface Link Cause
RAGG1 DOWN Not connected
Table 23 Command output
Field Description
Bridge-Aggregation1/Route-Aggr
egation1 current state
The Layer 2/Layer 3 interface status, which can be:
• DOWN ( Administratively )—The interface is administratively shut
down with the shutdown command.
• DOWN—The interface is administratively up but physically down
(possibly because no physical link is present or the link is faulty).
• UP—The Ethernet interface is both administratively and physically up.
Unknown-speed mode,
unknown-duplex mode
The interface speed and duplex mode are unknown.
PVID The default VLAN ID.
Last clearing of counters
Time when the reset counters interface command was last used to clear
the interface statistics.
If the reset counters interface command has never been used on the
interface since the device's startup, this field displays Never.
Last 300 seconds input/output Average input/output rate over the last 300 seconds.
Input/Output (total) Statistics of all packets received/sent on the interface.