R3721-F3210-F3171-HP High-End Firewalls High Availability Command Reference-6PW101

110
Use undo link-aggregation selected-port maximum to restore the default setting.
By default, the maximum number of Selected ports allowed in an aggregation group depends on the
hardware capabilities of the member ports.
Executing this command might cause some of the selected member ports in the aggregation group to
become unselected.
The following matrix shows the command and firewall compatibility:
Command F1000-A-EI/S-EI F1000-E F5000 Firewall module
link-aggregation selected-port
maximum
No No Yes No
Examples
# Configure the maximum number of Selected ports allowed as 3 in the aggregation group
corresponding to Layer 2 aggregate interface Bridge-Aggregation 1.
<Sysname> system-view
[Sysname] interface bridge-aggregation 1
[Sysname-Bridge-Aggregation1] link-aggregation selected-port maximum 3
link-aggregation selected-port minimum
Syntax
link-aggregation selected-port minimum number
undo link-aggregation selected-port minimum
View
Layer 2 aggregate interface view, Layer 3 aggregate interface view
Default level
2: System level
Parameters
number: Specifies the minimum number of Selected ports in an aggregation group required to bring up
the aggregate interface, in the range of 1 to 8.
Description
Use link-aggregation selected-port minimum to configure the minimum number of Selected ports in the
aggregation group.
Use undo link-aggregation selected-port minimum to restore the default setting.
By default, the minimum number of Selected ports in an aggregation group is not specified.
Executing this command may cause all the member ports in the aggregation group to become
unselected.
The following matrix shows the command and firewall compatibility:
Command F1000-A-EI/S-EI F1000-E F5000 Firewall module
link-aggregation selected-port minimum No No Yes No