R3721-F3210-F3171-HP High-End Firewalls High Availability Command Reference-6PW101

15
Use undo vrrp vrid virtual-ip to remove an existing VRRP group or the virtual IP address of the VRRP
group.
By default, no VRRP group is created.
The system removes a VRRP group after you delete all the virtual IP addresses in it.
The virtual IP address of a VRRP group cannot be 0.0.0.0, 255.255.255.255, loopback address, non
A/B/C address and other illegal IP addresses such as 0.0.0.1.
A VRRP group operates properly only when the configured virtual IP address and the interface IP address
belong to the same segment and are legal host addresses. If they are not in the same network segment,
or the configured IP address is the network address or network broadcast address of the network
segment to which the interface IP address belongs, though you can perform the configuration successfully,
the state of the VRRP group is always Initialize, which means VRRP does not take effect .
Related commands: display vrrp.
Examples
# Create VRRP group 1 and set its virtual IP address to 10.10.10.10.
<Sysname> system-view
[Sysname] interface GigabitEthernet 0/1
[Sysname-GigabitEthernet0/1] vrrp vrid 1 virtual-ip 10.10.10.10
# Add virtual IP address 10.10.10.11 to VRRP group 1.
[Sysname-GigabitEthernet0/1] vrrp vrid 1 virtual-ip 10.10.10.11
IPv6-based VRRP configuration commands
display vrrp ipv6
Syntax
display vrrp ipv6 [ verbose ] [ interface interface-type interface-number [ vrid virtual-router-id ] ] [ |
{ begin | exclude | include } regular-expression ]
View
Any view
Default level
1: Monitor level
Parameters
verbose: Displays detailed state information of VRRP groups.
interface interface-type interface-number: Displays VRRP group state information of the specified
interface. interface-type interface-number specifies an interface by its type and number.
vrid virtual-router-id: Displays state information of the specified VRRP group. virtual-router-id specifies a
VRRP group by its group number, which ranges from 1 to 255.
|: Filters command output by specifying a regular expression. For more information about regular
expressions, see Getting Started Guide.
begin: Displays the first line that matches the specified regular expression and all lines that follow.
exclude: Displays all lines that do not match the specified regular expression.