R3721-F3210-F3171-HP High-End Firewalls High Availability Configuration Guide-6PW101

108
Configuring UDP jitter tests
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter NQA test group view.
nqa entry admin-name
operation-tag
N/A
3. Configure the test type as UDP
jitter and enter test type view.
type udp-jitter N/A
4. Configure the destination
address of UDP packets.
destination ip ip-address
By default, no destination IP address is
configured.
The destination IP address must be the
same as that of the listening service on
the NQA server.
5. Configure the destination port
of UDP packets.
destination port port-number
By default, no destination port number is
configured.
The destination port must be the same as
that of the listening service on the NQA
server.
6. Specify the source port
number of UDP packets.
source port port-number
Optional.
By default, no source port number is
specified.
7. Configure the size of the data
field in each UDP packet.
data-size size
Optional.
100 bytes by default.
8. Configure the string to be
filled in the data field of each
probe packet.
data-fill string
Optional.
By default, the string is the hexadecimal
number 00010203040506070809.
9. Configure the number of
probe packets to be sent
during each UDP jitter probe
operation.
probe packet-number
packet-number
Optional.
10 by default.
10. Configure the interval for
sending probe packets during
each UDP jitter probe
operation.
probe packet-interval
packet-interval
Optional.
20 milliseconds by default.
11. Configure the interval the
NQA client must wait for a
response from the server
before it regards the response
is timed out.
probe packet-timeout
packet-timeout
Optional.
3000 milliseconds by default.
12. Configure the source IP
address for UDP jitter packets.
source ip ip-address
Optional.
By default, no source IP address is
specified.
The source IP address must be the IP
address of a local interface. The local
interface must be up; otherwise, no
probe packets can be sent out.