R3721-F3210-F3171-HP High-End Firewalls High Availability Configuration Guide-6PW101

109
Ste
p
Command Remarks
13. Configure optional
parameters.
See "Configuring optional
parameters for an NQA test
group"
Optional.
NOTE:
The probe count command specifies the number of probe operations during one UDP jitter test. The probe
packet-number command specifies the number of probe packets sent in each UDP jitter probe operation.
Configuring SNMP tests
SNMP tests of an NQA test group are used to test the time the NQA client takes to send an SNMP packet
to the SNMP agent and receive a response.
Before you start SNMP tests, enable the SNMP agent function on the device that serves as an SNMP
agent. For more information about SNMP agent configuration, see System Management and
Maintenance Configuration Guide.
To configure SNMP tests:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter NQA test group
view.
nqa entry admin-name
operation-tag
N/A
3. Configure the test type as
SNMP and enter test type
view.
type snmp N/A
4. Configure the destination
address of SNMP packets.
destination ip ip-address
By default, no destination IP address is
configured.
5. Specify the source port of
SNMP packets.
source port port-number
Optional.
By default, no source port number is
specified.
6. Configure the source IP
address of SNMP packets.
source ip ip-address
Optional.
By default, no source IP address is specified.
The source IP address must be the IP address
of a local interface. The local interface must
be up; otherwise, no probe packets can be
sent out.
7. Configure optional
parameters.
See "Configuring optional
parameters for an NQA test
group"
Optional.
Configuring TCP tests
TCP tests of an NQA test group are used to test the TCP connection between the NQA client and a port
on the NQA server and the time for setting up a connection. The test result helps you understand the
availability and performance of the services provided by the port on the server.