R3721-F3210-F3171-HP High-End Firewalls High Availability Configuration Guide-6PW101

111
Ste
p
Command Remarks
3. Configure the test type as UDP
echo and enter test type view.
type udp-echo N/A
4. Configure the destination
address of UDP packets.
destination ip ip-address
By default, no destination IP address is
configured.
The destination address must be the same
as the IP address of the listening service
configured on the NQA server.
5. Configure the destination port
of UDP packets.
destination port
port-number
By default, no destination port number is
configured.
The destination port number must be the
same as that of the listening service on the
NQA server.
6. Configure the size of the data
field in each UDP packet.
data-size size
Optional.
100 bytes by default.
7. Configure the string to be
filled in the data field of each
UDP packet.
data-fill string
Optional.
By default, the string is the hexadecimal
number 00010203040506070809.
8. Specify the source port of UDP
packets.
source port port-number
Optional.
By default, no source port number is
specified.
9. Configure the source IP
address of UDP packets.
source ip ip-address
Optional.
By default, no source IP address is
specified.
The source IP address must be that of an
interface on the device and the interface
must be up; otherwise, no probe packets
can be sent out.
10. Configure optional
parameters.
See "Configuring optional
parameters for an NQA
test group"
Optional.
Configuring DLSw tests
DLSw tests of an NQA test group are used to test the response time of a DLSw device.
Before you start DLSw tests, enable the DLSw function on the peer device.
To configure DLSw tests:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter NQA test group view.
nqa entry admin-name
operation-tag
N/A
3. Configure the test type as
DLSw and enter test type view.
type dlsw N/A