R3721-F3210-F3171-HP High-End Firewalls High Availability Configuration Guide-6PW101

116
Ste
p
Command Remarks
5. Configure the interval
between two consecutive tests
for a test group.
frequency interval
Optional.
By default, the interval between two
consecutive tests for a test group is 0
milliseconds. Only one test is performed.
If the last test is not completed when the
interval specified by the frequency
command is reached, a new test does not
start.
6. Configure the number of
probe operations to be
performed in one test.
probe count times
Optional.
By default, one probe operation is
performed in one test.
7. Configure the NQA probe
timeout time.
probe timeout timeout
Optional.
By default, the timeout time is 3000
milliseconds.
Not available for UDP jitter tests.
8. Configure the maximum
number of hops a probe
packet traverses in the
network.
ttl value
Optional.
20 by default.
Not available for DHCP tests.
9. Configure the ToS field in an
IP packet header in an NQA
probe packet.
tos value
Optional.
0 by default.
Not available for DHCP tests.
10. Enable the routing table
bypass function.
route-option bypass-route
Optional.
Disabled by default.
Not available for DHCP tests.
Configuring a schedule for an NQA test group
You can configure a schedule for an NQA test group by setting the start time and test duration for a test
group.
A test group performs tests between the scheduled start time and the end time (the start time plus test
duration). If the scheduled start time is ahead of the system time, the test group starts testing immediately.
If both the scheduled start and end time are behind the system time, no test will start. To view the current
system time, use the display clock command.
Configuration prerequisites
Before you configure a schedule for an NQA test group, complete the following tasks:
• Configure test parameters required for the test type.
• Configure the NQA server for tests that require cooperation with the NQA server.
Scheduling an NQA test group