R3721-F3210-F3171-HP High-End Firewalls High Availability Configuration Guide-6PW101

123
# Start HTTP tests.
[Firewall] nqa schedule admin test start-time now lifetime forever
# Stop HTTP tests after a period of time.
[Firewall] undo nqa schedule admin test
# Display results of the last HTTP test.
[Firewall] display nqa result admin test
NQA entry (admin admin, tag test) test results:
Destination IP address: 10.2.2.2
Send operation times: 1 Receive response times: 1
Min/Max/Average round trip time: 64/64/64
Square-Sum of round trip time: 4096
Last succeeded probe time: 2007-11-22 10:12:47.9
Extended results:
Packet loss in test: 0%
Failures due to timeout: 0
Failures due to disconnect: 0
Failures due to no connection: 0
Failures due to sequence error: 0
Failures due to internal error: 0
Failures due to other errors:
Packet(s) arrived late: 0
# Display the history of HTTP tests.
[Firewall] display nqa history admin test
NQA entry (admin admin, tag test) history record(s):
Index Response Status Time
1 64 Succeeded 2007-11-22 10:12:47.9
UDP jitter test configuration example
Network requirements
As shown in Figure 54, configure NQA UDP jitter tests to test the delay jitter of packet transmission
between Firewall A and Firewall B.
Figure 54 Network diagram
Configuration procedure
NOTE:
Before you make the configuration, make sure the devices can reach each other.
1. Configure Firewall B:
# Enable the NQA server and configure a listening service to listen to IP address 10.2.2.2 and
UDP port 9000.