R3721-F3210-F3171-HP High-End Firewalls High Availability Configuration Guide-6PW101

127
# Stop the SNMP tests after a period of time.
[FirewallA] undo nqa schedule admin test
# Display the results of the last SNMP test.
[FirewallA] display nqa result admin test
NQA entry (admin admin, tag test) test results:
Destination IP address: 10.2.2.2
Send operation times: 1 Receive response times: 1
Min/Max/Average round trip time: 50/50/50
Square-Sum of round trip time: 2500
Last succeeded probe time: 2007-11-22 10:24:41.1
Extended results:
Packet loss in test: 0%
Failures due to timeout: 0
Failures due to disconnect: 0
Failures due to no connection: 0
Failures due to sequence error: 0
Failures due to internal error: 0
Failures due to other errors: 0
Packet(s) arrived late: 0
# Display the history of SNMP tests.
[FirewallA] display nqa history admin test
NQA entry (admin admin, tag test) history record(s):
Index Response Status Time
1 50 Timeout 2007-11-22 10:24:41.1
TCP test configuration example
Network requirements
As shown in Figure 56, configure NQA TCP tests to test the time for establishing a TCP connection
between Firewall A and Firewall B.
Figure 56 Network diagram
Configuration procedure
NOTE:
Before you make the configuration, make sure the devices can reach each other.
1. Configure Firewall B:
# Enable the NQA server and configure a listening service to listen to IP address 10.2.2.2 and
TCP port 9000.
<FirewallB> system-view
[FirewallB] nqa server enable