R3721-F3210-F3171-HP High-End Firewalls High Availability Configuration Guide-6PW101

130
Failures due to sequence error: 0
Failures due to internal error: 0
Failures due to other errors: 0
Packet(s) arrived late: 0
# Display the history of UDP echo tests.
[FirewallA] display nqa history admin test
NQA entry (admin admin, tag test) history record(s):
Index Response Status Time
1 25 Succeeded 2007-11-22 10:36:17.9
DLSw test configuration example
Network requirements
As shown in Figure 58, configure NQA DLSw tests to test the response time of the DLSw device.
Figure 58 Network diagram
Configuration procedure
NOTE:
Before you make the configuration, make sure the devices can reach each other.
# Create a DLSw test group and configure DLSw probe packets to use 10.2.2.2 as the destination IP
address.
<Firewall> system-view
[Firewall] nqa entry admin test
[Firewall-nqa-admin-test] type dlsw
[Firewall-nqa-admin-test-dlsw] destination ip 10.2.2.2
# Enable the saving of history records.
[Firewall-nqa-admin-test-dlsw] history-record enable
[Firewall-nqa-admin-test-dlsw] quit
# Start DLSw tests.
[Firewall] nqa schedule admin test start-time now lifetime forever
# Stop the DLSw tests after a period of time.
[Firewall] undo nqa schedule admin test
# Display the result of the last DLSw test.
[Firewall] display nqa result admin test
NQA entry (admin admin, tag test) test results:
Destination IP address: 10.2.2.2
Send operation times: 1 Receive response times: 1
Min/Max/Average round trip time: 19/19/19
Square-Sum of round trip time: 361