R3721-F3210-F3171-HP High-End Firewalls High Availability Configuration Guide-6PW101

131
Last succeeded probe time: 2007-11-22 10:40:27.7
Extended results:
Packet loss in test: 0%
Failures due to timeout: 0
Failures due to disconnect: 0
Failures due to no connection: 0
Failures due to sequence error: 0
Failures due to internal error: 0
Failures due to other errors: 0
Packet(s) arrived late: 0
# Display the history of DLSw tests.
[Firewall] display nqa history admin test
NQA entry (admin admin, tag test) history record(s):
Index Response Status Time
1 19 Succeeded 2007-11-22 10:40:27.7
NQA collaboration configuration example
Network requirements
As shown in Figure 59, on Firewall configure a static route to Router B, with Router A as the next hop.
Associate the static route, track entry, and NQA test group to verify whether the static route is active in
real time.
Figure 59 Network diagram
Configuration procedure
1. Assign each interface an IP address. (Details not shown.)
2. On Firewall, configure a unicast static route and associate the static route with a track entry.
# Configure a static route, whose destination address is 10.2.1.1, and associate the static route
with track entry 1.
<Firewall> system-view
[Firewall] ip route-static 10.1.1.2 24 10.2.1.1 track 1
3. On Firewall, create an NQA test group:
# Create an NQA test group with the administrator name being admin and operation tag being
test.
[Firewall] nqa entry admin test
# Configure the test type of the NQA test group as ICMP echo.
GE0/2
10.1.1.1/24
GE0/1
10.1.1.2/24
GE0/1
10.2.1.1/24
Router B
GE0/1
10.2.1.2/24
Router A
Firewall