R3721-F3210-F3171-HP High-End Firewalls High Availability Configuration Guide-6PW101
147
2. Select GigabitEthernet 0/1, GigabitEthernet 0/2, and GigabitEthernet 0/3 on the chassis front
panel.
3. Click Apply.
Configuring link aggregation at the CLI
Ethernet link aggregation configuration task list
Task Remarks
Configuring an
aggregation group
Configuring a static aggregation group
Perform either t
ask.
Configuring a dynamic aggregation group
Configuring an
aggregate interface
Configuring the description of an aggregate interface or
subinterface
Optional.
Configuring the MTU of a Layer 3 aggregate interface or
subinterface
Optional.
Enabling link state traps for an aggregate interface Optional.
Limiting the number of Selected ports for an aggregation
group
Optional.
Shutting down an aggregate interface Optional.
Restoring the default settings for an aggregate interface
Optional.
Configuring load sharing for link aggregation groups Optional.
Configuring an aggregation group
You can choose to create a Layer 2 or Layer 3 link aggregation group depending on the ports to be
aggregated:
• To aggregate Layer 2 Ethernet interfaces, create a Layer 2 link aggregation group.
• To aggregate Layer 3 Ethernet interfaces, create a Layer 3 link aggregation group.
NOTE:
• You cannot add a port with any of the following functions enabled to a Layer 2 aggregation group:
packet filtering (
Attack Protection Configuration Guide
), Ethernet frame filtering (
Attack Protection
Configuration Guide
), and portal-free rule (
Access Control Configuration Guide
).
• You cannot add a port with any of the following functions enabled to a Layer 3 aggregation group: IP
address (
Network Management Configuration Guide
), DHCP client (
Network Management
Configuration Guide
), BOOTP client (
Network Management Configuration Guide
), VRRP (
Network
Management Configuration Guide
), and Portal (
Access Control Configuration Guide
).
CAUTION:
Removing an a
gg
re
g
ate interface also removes the correspondin
g
a
gg
re
g
ation
g
roup. At the same time,
all member ports leave the aggregation group.
Configuring a static aggregation group