R3721-F3210-F3171-HP High-End Firewalls High Availability Configuration Guide-6PW101

148
NOTE:
To guarantee a successful static aggregation, make sure that the ports at both ends of each link are in the
same aggregation state.
To configure a Layer 2 static aggregation group:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Create a Layer 2
aggregate interface
and enter Layer 2
aggregate interface
view.
interface bridge-aggregation
interface-number
When you create a Layer 2 aggregate
interface, the system automatically creates a
Layer 2 static aggregation group numbered
the same.
3. Exit to system view.
quit N/A
4. Assign an Ethernet
interface to the
aggregation group.
a. Enter Layer 2 Ethernet
interface view:
interface interface-type
interface-number
b. Assign the Ethernet
interface to the
aggregation group:
port link-aggregation
group number
Repeat this step to assign more Layer 2
Ethernet interfaces to the aggregation group.
5. Assign the port an
aggregation priority.
link-aggregation port-priority
port-priority
Optional.
By default, the aggregation priority of a port
is 32768.
When the number of candidate selected
ports is greater than the maximum number of
selected ports allowed in a static
aggregation group, changing the
aggregation priority of a port may affect the
aggregation state of the ports in the static
aggregation group.
To configure a Layer 3 static aggregation group:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Create a Layer 3 aggregate
interface and enter Layer 3
aggregate interface view.
interface route-aggregation
interface-number
When you create a Layer 3
aggregate interface, the system
automatically creates a Layer 3
static aggregation group
numbered the same.
3. Exit to system view.
quit N/A