R3721-F3210-F3171-HP High-End Firewalls High Availability Configuration Guide-6PW101

150
Ste
p
Command Remarks
4. Configure the
aggregation group to
operate in dynamic
aggregation mode.
link-aggregation mode dynamic
By default, an aggregation group
operates in static aggregation mode.
5. Exit to system view.
quit N/A
6. Assign an Ethernet
interface to the
aggregation group.
a. Enter Layer 2 Ethernet interface
view:
interface interface-type
interface-number
b. Assign the Ethernet interface to
the aggregation group:
port link-aggregation group
number
Repeat this step to assign more Layer
2 Ethernet interfaces to the
aggregation group.
7. Assign the port an
aggregation priority.
link-aggregation port-priority
port-priority
Optional.
By default, the aggregation priority
of a port is 32768.
Changing the aggregation priority of
a port might affect the aggregation
state of the ports in the dynamic
aggregation group.
8. Set the LACP timeout
interval on the port to
the short timeout
interval (1 second).
lacp period short
Optional.
By default, the LACP timeout interval
on a port is the long timeout interval
(30 seconds).
To configure a Layer 3 dynamic aggregation group:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Set the system LACP
priority.
lacp system-priority system-priority
Optional.
By default, the system LACP priority is
32768.
Changing the system LACP priority might
affect the aggregation state of the ports
in the dynamic aggregation group.
3. Create a Layer 3
aggregate interface
and enter Layer 3
aggregate interface
view.
interface route-aggregation
interface-number
When you create a Layer 3 aggregate
interface, the system automatically
creates a Layer 3 static aggregation
group numbered the same.
4. Configure the
aggregation group to
operate in dynamic
aggregation mode.
link-aggregation mode dynamic
By default, an aggregation group
operates in static aggregation mode.
5. Exit to system view.
quit N/A