R3721-F3210-F3171-HP High-End Firewalls High Availability Configuration Guide-6PW101

151
Ste
p
Command Remarks
6. Assign an Ethernet
interface to the
aggregation group.
a. Enter Layer 3 Ethernet
interface view:
interface interface-type
interface-number
b. Assign the Ethernet interface
to the aggregation group:
port link-aggregation group
number
Repeat this step to assign more Layer 3
Ethernet interfaces to the aggregation
group.
7. Assign the port an
aggregation priority.
link-aggregation port-priority
port-priority
Optional.
By default, the aggregation priority of a
port is 32768.
Changing the aggregation priority of a
port might affect the aggregation state of
ports in the dynamic aggregation group.
8. Set the LACP timeout
interval on the port to
the short timeout
interval (1 second).
lacp period short
Optional.
By default, the LACP timeout interval on a
port is the long timeout interval (30
seconds).
Configuring an aggregate interface
NOTE:
In addition to the preceding confi
g
urations, most of the confi
g
urations that can be performed on Layer 2
or Layer 3 Ethernet interfaces can also be performed on Layer 2 or Layer 3 aggregate interfaces.
Configuring the description of an aggregate interface or subinterface
You can configure the description of an aggregate interface for administration purposes such as
describing the purpose of the interface.
To configure the description of an aggregate interface or subinterface:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter aggregate
interface view.
• Enter Layer 2 aggregate interface
view:
interface bridge-aggregation
interface-number
• Enter Layer 3 aggregate interface or
subinterface view:
interface route-aggregation
{ interface-number |
interface-number.subnumber }
Use either command.