R3721-F3210-F3171-HP High-End Firewalls High Availability Configuration Guide-6PW101

154
Ste
p
Command Remarks
4. Set the maximum number of Selected
ports for the aggregation group.
link-aggregation selected-port
maximum number
By default, the maximum
number of Selected ports
allowed in an aggregation
group depends on only the
hardware capabilities of
the member ports.
Shutting down an aggregate interface
Shutting down or bringing up an aggregate interface affects the aggregation state and link state of ports
in the corresponding aggregation group in the following ways:
• When an aggregate interface is shut down, all Selected ports in the corresponding aggregation
group become unselected and their link state becomes down.
• When an aggregate interface is brought up, the aggregation state of ports in the corresponding
aggregation group is recalculated and their link state becomes up.
To shut down an aggregate interface:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter aggregate interface
view.
• Enter Layer 2 aggregate interface
view:
interface bridge-aggregation
interface-number
• Enter Layer 3 aggregate interface
view:
interface route-aggregation
interface-number
Use either command.
3. Shut down the aggregate
interface or subinterface.
shutdown
By default, aggregate interfaces
or subinterfaces are up.
NOTE:
Shutting down a Layer 3 aggregate subinterface does not affect any aggregation group, because Layer 3
aggregate subinterfaces are not associated with any aggregation groups.
Restoring the default settings for an aggregate interface
To restore the default settings for an aggregate interface:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter aggregate
interface view.
• Enter Layer 2 aggregate interface view:
interface bridge-aggregation interface-number
• Enter Layer 3 aggregate interface or subinterface
view:
interface route-aggregation { interface-number |
interface-number.subnumber }
Use either
command.