R3721-F3210-F3171-HP High-End Firewalls High Availability Configuration Guide-6PW101

155
Ste
p
Command Remarks
3. Restore the default
settings for the
aggregate interface or
subinterface.
default N/A
Configuring load sharing for link aggregation groups
You can determine how traffic is load-shared in a link aggregation group by configuring load sharing
criteria. The criteria can be service port numbers, IP addresses, or IP protocols carried in packets, or any
combination.
You can configure global or group-specific load sharing criteria. A link aggregation group preferentially
uses the group-specific load sharing criteria. If no group-specific load sharing criteria is available, the
group uses the global load sharing criteria.
Configuring the global link-aggregation load sharing criteria
To configure the global link-aggregation load sharing criteria:
Ste
p
Command
1. Enter system view.
system-view
2. Configure the global
link-aggregation load sharing
criteria.
link-aggregation load-sharing mode { destination-ip | destination-port
| ip-protocol |source-ip | source-port } *
Configuring group-specific load sharing criteria
To configure load sharing criteria for a link aggregation group:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter aggregate
interface view.
• Enter Layer 2 aggregate interface view:
interface bridge-aggregation interface-number
• Enter Layer 3 aggregate interface view:
interface route-aggregation interface-number
Use either command.
3. Configure the load
sharing criteria for the
aggregation group.
link-aggregation load-sharing mode { destination-ip
| destination-port | ip-protocol | source-ip |
source-port } *
N/A