R3721-F3210-F3171-HP High-End Firewalls High Availability Configuration Guide-6PW101

21
Enabling the trap function for VRRP
When the trap function is enabled for VRRP, VRRP generates traps with severity level errors to report its
key events. The traps are sent to the information center of the firewall, where you can configure whether
to output the trap information and the output destination. For how to configure the information center, see
System Management and Maintenance Configuration Guide.
To enable the trap function for VRRP:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enable the trap function for
VRRP.
snmp-agent trap enable vrrp
[ authfailure | newmaster ]
Optional.
Enabled by default.
NOTE:
For more information about the snmp-agent trap enable vrrp command, see
System Management and
Maintenance Command Reference
.
Displaying and maintaining VRRP for IPv4
Task Command Remarks
Display VRRP group
status.
display vrrp [ verbose ] [ interface interface-type
interface-number [ vrid virtual-router-id ] ] [ | { begin |
exclude | include } regular-expression ]
Available in any view
Display VRRP group
statistics.
display vrrp statistics [ interface interface-type
interface-number [ vrid virtual-router-id ] ] [ | { begin |
exclude | include } regular-expression ]
Available in any view
Clear VRRP group
statistics.
reset vrrp statistics [ interface interface-type
interface-number [ vrid virtual-router-id ] ]
Available in user view
Configuring IPv6-based VRRP
NOTE:
The IPv6-based VRRP configuration is available only at the CLI.
IPv6-based VRRP configuration task list
Task Remarks
Specifying the type of MAC addresses mapped to virtual IPv6
addresses
Optional.
When VRRP operates in load
balancing mode, this configuration is
not effective.
Creating a VRRP group and configuring a virtual IPv6 address Required.
Configuring router priority, preemptive mode and tracking function Optional.