R3721-F3210-F3171-HP High-End Firewalls NAT and ALG Configuration Guide-6PW101

8
Table 4 Configuration items
Item Descri
p
tion
Index Specify the index of an address pool.
Start IP Address Specify the start IP address of the address pool.
End IP Address
Specify the end IP address of the address pool.
The end IP address must be identical to or higher than the start IP address.
Low priority
Configure the address pool as a low-priority or a non low-priority address pool.
IMPORTANT:
This configuration item is applicable to the stateful failover networking only. You cannot
configure the same address pool as the low-priority address pool on the local and peer
devices.
Configuring dynamic NAT
NOTE:
If Easy IP is configured on an interface or the public IP address is the same as the IP address of the
interface, address translation cannot be associated with any VRRP group.
Select Firewall > NAT Policy > Dynamic NAT from the navigation tree to enter the page shown in Figure
5. In the Dynamic NAT field where all dynamic NAT policies are displayed, click Add to enter the Add
Dynamic NAT page shown in Figure 7.
Figure 7 Adding dynamic NAT
Table 5 Configuration items
Item Descri
p
tion
Interface Specify an interface on which dynamic NAT is to be enabled.