Manualshelf

R3721-F3210-F3171-HP High-End Firewalls Network Management Command Reference-6PW101

ManualsBrandsHP ManualsComputer AccessoriesHP 7100/7200 IPsec dl Module
111112113114115116117118119120
93
View
Ethernet interface view, Layer 2 aggregate interface view
Default level
2: System level
Parameters
enable: Configures the ports as edge ports.
disable: Configures the ports as non-edge ports.
Description
Use stp edged-port enable to configure the ports as edge ports.
Use stp edged-port disable to configure the ports as non-edge ports.
Use undo stp edged-port to restore the default.
By default, all ports are non-edge ports.
Configured in Ethernet interface view, the setting takes effect on the interface only.
Configured in Layer 2 aggregate interface view, the setting takes effect only on the aggregate interface.
Configured on a member port in an aggregation group, the setting takes effect only after the port leaves
the aggregation group.
If a port directly connects to a user terminal rather than another device or a shared LAN segment, this
port is regarded as an edge port. When the network topology changes, an edge port will not cause a
temporary loop. You can enable the port to transition to the forwarding state rapidly by configuring it as
an edge port. HP recommends you to configure ports directly connecting to user terminals as edge ports.
Configuration BPDUs from other devices usually cannot reach an edge port, because the edge port does
not connect to any other device. If a port receives a configuration BPDU when the BPDU guard function
is disabled, the port functions as a non-edge port, even if you configure it as an edge port.
Among loop guard, root guard and edge port settings, only one function (whichever is configured the
earliest) takes effect on a port at the same time.
Related commands: stp loop-protection and stp root-protection.
Examples
# Configure GigabitEthernet 0/1 as an edge port.
<Sysname> system-view
[Sysname] interface gigabitethernet 0/1
[Sysname-GigabitEthernet0/1] stp edged-port enable
stp enable
Syntax
stp enable
undo stp enable
View
System view, Ethernet interface view, Layer 2 aggregate interface view