R3721-F3210-F3171-HP High-End Firewalls Network Management Command Reference-6PW101

120
undo ppp timer negotiate
View
VT interface view
Default level
2: System level
Parameters
seconds: Negotiation timeout time to be set, in the range of 1 to 10 (in seconds). In PPP negotiation, if
the local device receives no response from the peer during this period after it sends a packet, the local
device sends the last packet again.
Description
Use ppp timer negotiate to set the PPP negotiation timeout time.
Use undo ppp timer negotiate to restore the default.
By default, the PPP negotiation timeout time is three seconds.
Examples
# Set the PPP negotiation timeout time to five seconds.
<Sysname> system-view
[Sysname] interface Virtual-Template 10
[Sysname-Virtual-Template10] ppp timer negotiate 5
remote address
Syntax
remote address { ip-address | pool [ pool-number ] }
undo remote address
View
VT interface view
Default level
2: System level
Parameters
ip-address: IP address to be assigned to the peer device.
pool [ pool-number ]: Specifies the number of the address pool used for assigning an IP address to the
peer. The pool-number argument ranges from 0 to 99 and defaults to 0.
Description
Use remote address to set the IP address to be assigned to the peer device or specify the address pool
used for assigning an IP address to the peer device.
Use undo remote address to cancel the IP address configured to be assigned to the peer device.
By default, an interface does not assign IP addresses to the peer device.
The remote address command can be used when the local device is configured with an IP address, but
the peer has no IP address. To enable the peer device to accept the IP address assigned to it by the local